![]() Then recode with the manipulation profile the four parameters in the KOMBI again and that should do it. ![]() If you have any doubts just go back and default code the KOMBI, NFRM, JBBF, and CIC. It sounds like you may have lucked into getting it right anyways if you have no errors and the tach is working correctly. My profile names are factory coding and manipulation, can't get them confused. The way NCS Expert Tool is designed and how the profile used is setup, all ECU codings are loaded into the file FSWPSW.TRC whereas all coding modifications. Keep one that has manipulation checked and one that doesn't and since you found the profile editor open the profile info box and change the profile name of each to something that you know will differentiate between the two. Look to see if $2TC is gone and $2MK is there, they'll be at the front of your VO just a few characters in.Ĭheck your other profiles. ![]() Check your VO, it will show in NCS Expert after you pick CAS and hit back in your initial read. It's just easier to have the two different profiles rather than going back and forth changing one to fill both needs. Hi everyone I decided to share with you how to create a profile with NCS Expert, instead of searching and downloading existing one. 6) Make sure under button 'Individualisierung' all options are crossed. Usually there's two or three profiles listed, what are the names of yours? Keep in mind the profile name can be changed to anything you want. 3) Save as a new profile (give it a name, like the godfather or something powerful-sounding ).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |